Dell Pro 14 PC14250 Owner's Manual

PDF

Removing the USB Type-C module

CAUTION:The information in this removal section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the battery.
  4. Remove the memory module.
  5. Remove the SSD.
  6. Remove the wireless card.
  7. Remove the fan.
  8. Remove the heat sink.
  9. Remove the display assembly.
  10. Remove the system board (for computers shipped with Intel Core Series) or (for computers shipped with Intel Core Ultra 200U Series), whichever is applicable.

About this task

NOTE:The system board can be removed with the heat sink attached in order to simplify the procedure and preserve the thermal bond between the system board and the heat sink.
The following images indicate the location of the USB Type-C module and provide a visual representation of the removal procedure.
Figure 1. Removing the USB Type-C module
Image: Removing the USB Type-C module

Steps

  1. Turn the system board over and remove the three screws (M2x5) that secure the USB Type-C module to the bottom side of the system board.
  2. Remove the USB Type-C module from the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\