Dell Pro 14 PC14250 Owner's Manual

PDF

Removing the USH board FPC (For computers shipped with smart card reader)

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the battery.

About this task

The following image indicates the location of the USH board FPC and provides a visual representation of the removal procedure.
Figure 1. Removing the USH board FPC
Image: Removing the USH board FPC

Steps

  1. Peel off the protective film from the USH board .
  2. Open the latch and disconnect the USH board FPC from the connector (C6613) on the system board.
  3. Open the latch and disconnect the USH board FPC from the connector (CN661) on the USH board.
  4. Lift the USH board FPC off the palm-rest assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\