Dell Pro 14 PC14250 Owner's Manual

PDF

Removing the vPro cable (For computers shipped with Smart card reader)

CAUTION:The information in this removal section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.

About this task

The following image indicates the location of the vPro cable and provides a visual representation of the removal procedure.
Figure 1. Removing the vPro cable
Image: Removing the vPro cable

Steps

  1. Disconnect the vPro cable from the vPro connector on the I/O board.
  2. Disconnect the vPro cable from the connector on the system board.
  3. Unroute the vPro cable from the routing guide and lift it off the palm-rest and keyboard assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\