Windows 11 IoT Enterprise LTSC 2024 Deployment Guide

PDF

How do I deploy TightVNC using Wyse Management Suite (WMS)?

To deploy TightVNC, you must download the installer from the official TightVNC website. Follow the steps listed below to deploy TightVNC using WMS:

  1. Download the 64-bit TightVNC installer for Windows from the official TightVNC website.
  2. Add the TightVNC installer package to the WMS repository. How to add an application package to the WMS repository?
  3. Configure and schedule an application policy in WMS to deploy the TightVNC package to a group of devices. For instructions, see Deploying applications using WMS. When configuring the application policy, you must specify the following:
    • In the Install Parameters field, enter /quiet.
    • Select the Reboot option.
  4. To verify a successful installation of TightVNC, do one of the following:
    • Go to the Jobs page and confirm that the job status is Success.
    • Go to Devices > Device Details > Installed Apps for a target device and confirm that TightVNC is listed in Installed Apps.
NOTE:Remote session initiation default password is DELL and Default port number is 5900.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\