The
PERC Command Line Tool supports the following commands to set the
status of physical drives:
perccli /cx[/ex]/sx set jbod
perccli /cx[/ex]/sx set good [force]
perccli /cx[/ex]/sx set offline
perccli /cx[/ex]/sx set online
perccli /cx[/ex]/sall set jbod
perccli /cx[/ex]/sx-y set jbod
The detailed
description for each command follows.
perccli /cx[/ex]/sx set jbod
This command
converts unconfigured good drive to Non-RAID disks.
Input example:
perccli /c1/e56/s3 set jbod
perccli /cx[/ex]/sx set good [force]
This
drive changes the drive state to unconfigured good. If the drive has
the operating system in it, use the force option.
Input example:
perccli /c1/e56/s3 set good
perccli /cx[/ex]/sx set offline
This command
changes the drive state to offline.
Input example:
perccli /c1/e56/s3 set offline
perccli /cx[/ex]/sx set online
This command
changes the drive state to online.
Input example:
perccli /c1/e56/s3 set online
perccli /cx[/ex]/sall set jbod
This command
converts all unconfigured good drives to Non-RAID disks.
Input example:
perccli /c1/e56/sall set jbod
perccli /cx[/ex]/sx-y set jbod
This command
converts all the selected unconfigured good drives to Non-RAID disks.
Input example:
perccli /c1/e56/s1-6 set jbod
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\