Skip to main content
Contact Us

Dell 14 Plus DB14250 Owner's Manual

PDF

Installing the battery

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image indicates the location of the battery and provides a visual representation of the installation procedure.

Figure 1. Installing the battery
Image: Installing the battery

Steps

  1. Place the battery on the palm-rest and keyboard assembly.
  2. Align the screw holes on the battery with the screw holes on the palm-rest and keyboard assembly.
  3. Replace the four screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
  4. Connect the battery cable to the connector (BATT) on the system board.
  5. Adhere the tape that secures the battery cable to the connector on the system board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\