Skip to main content
Contact Us

Dell 14 Plus DB14250 Owner's Manual

PDF

Installing the heat sink

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

NOTE:If either the system board or the heat sink is replaced, use the thermal grease that is provided in the kit for thermal conductivity.

The following image indicates the location of the heat sink and provides a visual representation of the installation procedure.

Figure 1. Installing the heat sink
Image: Installing the heat sink

Steps

  1. Place the heat sink on the system board.
  2. Align the captive screws on the heat sink to the screw holes on the system board.
  3. In sequential order (1, 2, 3, 4), tighten the four captive screws that secure the heat sink to the system board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\