Skip to main content
Contact Us

Dell 14 Plus DB14250 Owner's Manual

PDF

Removing the display assembly

Prerequisites

  1. Follow the procedure in Before working inside your computer.
    NOTE:Ensure that your computer is in Service Mode. For more information, see step 7 in Before working inside your computer.
  2. Remove the base cover.

About this task

The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.

Figure 1. Removing the display assembly 1
Image: Removing the display assembly
Figure 2. Removing the display assembly 2
Image: Removing the display assembly
Figure 3. Display assembly
Image: Display assembly

Steps

  1. Peel the tape that secures the display-assembly cable to the latch on the system board.
  2. Lift the latch and disconnect the infrared camera cable from the connector (CIR) on the system board.
  3. Lift the latch and disconnect the display-assembly cable from the connector (LCD) on the system board.
  4. Remove the two screws (M2.5x5) that secure the left display-assembly hinge to the system board.
  5. Pry open the left display-assembly hinge to a 90-degree angle.
  6. Remove the three screws (M2.5x5) that secure the right display-assembly hinge to the system board.
  7. Pry open the right display-assembly hinge to a 90-degree angle.
  8. Lift the palm-rest and keyboard assembly at an angle off the display assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\