Skip to main content
Contact Us

Dell 14 Plus DB14250 Owner's Manual

PDF

Removing the palm-rest and keyboard assembly

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
    NOTE:Ensure that your computer is in Service Mode. For more information, see step 7 in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the battery.
  4. Remove the battery cable.
  5. Remove the M.2 2230 solid state drive.
  6. Remove the display assembly.
  7. Remove the fan.
  8. Remove the heat sink.
  9. Remove the wireless card.
  10. Remove the speaker assembly.
  11. Remove the system board.
    NOTE:The system board can be removed with the heat sink attached.
  12. Remove the I/O board.
  13. Remove the power button or the power button with optional fingerprint reader, whichever is applicable.
  14. Remove the touchpad.

About this task

The following image shows the palm-rest and keyboard assembly after all other components have been removed.

Figure 1. Palm-rest and keyboard assembly
Image: Palm-rest and keyboard assembly

Steps

After performing the steps in Prerequisites, you are left with the palm-rest and keyboard assembly.
NOTE:The palm-rest and keyboard assembly consists of the following:
  • Palm rest
  • Keyboard

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\