Skip to main content
Contact Us

Dell 14 Plus DB14250 Owner's Manual

PDF

Removing the power button with fingerprint reader

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
    NOTE:Ensure that your computer is in Service Mode. For more information, see step 7 in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the I/O board.
  4. .

About this task

The following image indicates the location of the power button with fingerprint reader and provides a visual representation of the removal procedure.

Figure 1. Removing the power button with fingerprint reader
Image: Removing the power button

Steps

  1. Remove the screw (M2x3) that secures the power button with fingerprint reader to the palm-rest and keyboard assembly.
  2. Peel back the tape that secures the fingerprint-reader cable to the palm-rest and keyboard assembly.
    NOTE:This step is only applicable for computers that are shipped with the power button with fingerprint reader.
  3. Lift the power button with fingerprint reader off the palm-rest and keyboard assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\