- Notes, cautions, and warnings
- Views of Dell 14 Plus DB14250
- Set up your Dell 14 Plus DB14250
- Specifications of Dell 14 Plus DB14250
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports and slots
- Internal slots
- Wireless module
- Audio
- Storage
- Keyboard
- Keyboard function keys
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Fingerprint reader (optional)
- GPU—Integrated
- External display support
- Operating and storage environment
- ComfortView
- ComfortView Plus
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Network power cycle
- Drain flea power (perform hard reset)
- Getting help and contacting Dell
- Revision history
Dell 14 Plus DB14250 Owner's Manual
Removing the touchpad
CAUTION:The information in this section is intended for authorized service technicians only.
Prerequisites
- Follow the procedure in
Before working inside your computer. NOTE:Ensure that your computer is in Service Mode. For more information, see step 7 in Before working inside your computer.
- Remove the base cover.
- Remove the battery.
About this task
NOTE:Before removing the base cover, ensure that
no SD card is installed in the SD card slot on your computer.
The following image indicates the location of the touchpad and provides a visual representation of the removal procedure.
Steps
- Pry open the touchpad cable connector latch and disconnect the touchpad cable from the touchpad cable connector (TP) on the system board.
- Pry open the touchpad cable connector latch and disconnect the touchpad cable from the touchpad cable connector on the touchpad.
- Lift the touchpad cable off the system board.
- Remove the two screws (M2x3) and the six screws (M1.6x1.5) that secure the touchpad bracket to the palm-rest and keyboard assembly.
- Peel back the tape on the upper right edge of the touchpad bracket.
- Lift the touchpad bracket off the palm-rest and keyboard assembly.
- Lift the touchpad off the palm-rest and keyboard assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\