- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Latitude 9430
- Secure Digital (SD) Card
- SIM card tray
- Base cover
- Solid-state drive
- Wireless Wide Area Network (WWAN) Card
- System fan
- Heat sink
- Display assembly
- Battery
- Speakers
- Wireless Local Area Network (WLAN) Antenna module
- I/O daughter board
- Power button with fingerprint reader assembly
- System board
- USH daughter board
- Wireless Wide Area Network (WWAN) Antenna module
- Palm-rest assembly
- Drivers and downloads
- BIOS setup
- Keyboard shortcuts
- Troubleshooting
- Getting help and contacting Dell
Latitude 9430/Latitude 9430 2-in-1 Service Manual
Installing the battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the battery and provides a visual representation of the installation procedure.
NOTE If battery was disconnected from system board for service, there will be a delay during system boot-up as the system will undergo RTC battery reset.
Steps
- Align and place the battery on the palm-rest assembly.
- Replace the single (M1.6x3) screw and four (M2x4) screws to secure the battery to the palm-rest assembly.
- Reconnect the battery cable to the connector on the system board.
- Route the speaker cables in the routing guides at the left and right side of the battery.
- Adhere the piece of tape securing the speaker cable in place at the left side of the battery.
- Route the speaker cable in the routing guides along the top side of the battery and connect the speaker cable to the connector on the system board.
- Route the WLAN antenna cables and blue WWAN antenna cable in the metal clips on the system board and the routing guides along the sides of the battery.
- Connect the antenna cables to the WLAN module.
- Align and place the WLAN bracket on the system board.
- Tighten the single captive screw securing the WLAN bracket to the system board.
- Adhere the piece of tape securing the WLAN antenna cables in place at the top side of the battery.
- Adhere the two pieces of tape securing the gray WWAN antenna cable in place at the bottom side of CPU shielding cover and route the wireless antenna cables in the routing guides on the system board and the routing guides along the top side of the battery.
Next steps
- Install the WWAN card.
- Install the base cover.
- Install the SIM card tray.
- Install the SD card.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\