- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Latitude 9430
- Secure Digital (SD) Card
- SIM card tray
- Base cover
- Solid-state drive
- Wireless Wide Area Network (WWAN) Card
- System fan
- Heat sink
- Display assembly
- Battery
- Speakers
- Wireless Local Area Network (WLAN) Antenna module
- I/O daughter board
- Power button with fingerprint reader assembly
- System board
- USH daughter board
- Wireless Wide Area Network (WWAN) Antenna module
- Palm-rest assembly
- Drivers and downloads
- BIOS setup
- Keyboard shortcuts
- Troubleshooting
- Getting help and contacting Dell
Latitude 9430/Latitude 9430 2-in-1 Service Manual
Installing the left speaker
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the speaker and provides a visual representation of the installation procedure.
Steps
- Align and place the left speaker in the slot on the system.
- Replace the single (M1.6x1.8) screw that secures the left speaker to the system.
- Route the speaker cables through the routing guide and connect the speaker cable to the connector on the system board.
- Connect the Proximity sensor cable of the left speaker's WWAN antenna module to the RF board.
- Replace the single (M1.6x1.8) screw securing the Proximity sensor bracket to the palmrest assembly.
Next steps
- Install the battery.
- Install the WWAN card.
- Install the base cover.
- Install the SIM card tray.
- Install the SD card.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\