Skip to main content
Contact Us

Latitude 9430/Latitude 9430 2-in-1 Service Manual

PDF

Removing the palm-rest assembly

Prerequisites

  1. Follow the procedure in Before working inside your computer.
    NOTE Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your computer.
  2. Remove the SD card.
  3. Remove the SIM card tray.
  4. Remove the base cover.
  5. Remove the solid-state drive.
  6. Remove the WWAN card.
  7. Remove the heat sink.
  8. Remove the display assembly.
  9. Remove the battery.
  10. Remove the left speaker.
  11. Remove the right speaker.
  12. Remove the WLAN antenna module.
  13. Remove the I/O daughter board.
  14. Remove the power button with fingerprint reader assembly (for systems shipped with a fingerprint reader).
  15. Remove the system board.
  16. Remove the USH daughter board.
  17. Remove the WWAN main antenna module.

About this task

The following images indicate the location of the palm-rest assembly and provide a visual representation of the removal procedure.

Remove Palnrest assembly

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\