Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge R330 Owner's Manual

PDF

Installing the internal PERC card

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

  3. Remove the expansion card riser.

  4. Keep the Phillips #2 screwdriver ready.

Steps

  1. Connect the PERC LED cable to the LED cable connector on the PERC card.
  2. Insert the PERC card in the PERC card slot.
  3. Press and slide the tab on the PERC card lock to disengage it from the slot on the chassis.
  4. Turn the internal PERC card lock to engage it with the PERC card.
  5. Install the first screw to secure the PERC card lock to the PERC card.
  6. Install the second screw to secure the PERC card to the chassis.

    NOTE: Use the two screws supplied with the system to secure the PERC card to the PERC card lock and the chassis

  7. Connect the PERC LED cable to the LED cable connector on the system board.
    Figure 1. Installing the internal PERC card
    This figure shows installing the internal PERC card
    Figure 2. Closing the PERC card lock
    This figure shows closing the PERC card lock

Next steps

  1. Install the expansion card riser.
  2. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\