CAUTION:Many repairs may only
be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation,
or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that are
shipped with your product.
Steps
Align the slots on the two ends of the backplane
expander board with the guide pins on the hard drive backplane.
Holding the backplane expander board by the
release lever, slide it into the connectors on the hard drive backplane,
until fully seated.
The securing screws and standoff on the release
lever (under the expander board) slide into the slots on the expander
board bracket on the hard drive backplane.
Rotate the release lever inward until it is
level with the expander board and the expander board connectors engage
with the hard drive backplane connectors.
Connect the SAS cables to the backplane expander
board.
Reinstall the cooling fan assembly.
Reinstall the cooling shroud.
Close the system.
If applicable, place the system upright on
a flat, stable surface and rotate the system feet outward.
If removed, reinstall the hard drives, server
modules, and power supply units.
Reconnect the enclosure to its electrical
outlet and turn the enclosure on, including any attached peripherals.
Turn on the server modules using the operating
system commands or the CMC.
If applicable, install the front bezel.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\