Dell OptiPlex 7020 Small Form Factor Owner's Manual

PDF

Installing the Drive Cage

  1. Place the drive cage on the edge of the computer to allow access to the cable connectors on the hard drive.
  2. Connect the data and power cables to the back of the hard drive.
  3. Flip over the drive cage and insert it into the chassis. The drive cage tabs are secured by the slots in the chassis.
  4. Slide the drive-cage handle toward the locked position.
  5. Install the:
    1. front bezel
    2. optical drive
    3. cover
  6. Follow the procedures in After Working Inside Your Computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\