Dell OptiPlex 7020 Small Form Factor Owner's Manual

PDF

Installing the Input/Output (I/O) Panel

  1. Insert the I/O panel into the slot on the chassis front.
  2. Slide the I/O panel to secure it to the chassis.
  3. Tighten the screw to secure the I/O panel to the chassis.
  4. Connect the I/O panel or FlyWire cable and audio cable to the system board.
  5. Thread the I/O panel or FlyWire cable into the fan-shelter clip.
  6. Install the:
    1. drive cage
    2. optical drive
    3. front bezel
    4. cover
  7. Follow the procedures in After Working Inside Your Computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\