Dell OptiPlex 7020 Small Form Factor Owner's Manual

PDF

Installing the System Board

  1. Align the system board to the port connectors on the rear of the chassis and place the system board in the chassis.
  2. Tighten the screws securing the system board to the chassis.
  3. Tighten the hex screw to the system board.
  4. Connect the cables to the system board.
  5. Install the:
    1. processor
    2. power supply
    3. heat-sink assembly
    4. expansion card(s)
    5. memory
    6. drive cage
    7. optical drive
    8. front bezel
    9. cover
  6. Follow the procedures in After Working Inside Your Computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\