Dell Command | Update Version 2.0 User's Guide

Adding Settings In A Policy File

Perform the following steps to add the settings in a policy file:
  1. Open the saved policy.xml file in an XML editor and add a new <setting> element with a valid name and value. For setting the values, refer to the Settings And Applicable Values table. For example: <setting name=”scehduledminute”>30</setting>
  2. Save the file as an XML file and place it in the Dell Command | Update installation directory and launch the application.
    • NOTE: Save the policy.xml file in a different location before you use it as, Dell Command | Update loads the policy data and deletes the policy file. You can use the saved policy file for modifying the policy settings.
    • NOTE: It is mandatory to name the file as policy.xml and place it in the installation directory for Dell Command | Update to recognize it as a policy file to be imported.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\