Dell Command | Update Version 2.0 User's Guide

Configuring Advanced Driver Restore Settings

In the Advanced Driver Restore tab, you can configure the location to download the driver library for a new or reconditioned system.

Perform the following steps to configure the Advanced Driver Restore settings:
  1. On the heading banner, click Settings.
  2. On the Settings screen, click Advanced Driver Restore.
  3. Click Enable to enable or disable the Advanced Driver Restore for Windows Reinstallation option on the Welcome screen. By default, the feature is:
    • enabled when you install Dell Command | Update on your system.
    • disabled if Dell Command | Update is factory installed.
    • disabled if you upgrade from Dell Client System Update 1.3 to Dell Command | Update 2.0.
    After the drivers are installed on the system, the feature is disabled.
  4. Select one of the following options:
    • Download Driver library from Dell Update/Support Site (Recommended) : To download the driver library from the dell.com/support.
    • Use the specified driver library: To download the driver library from a local or network location. Click Browse to specify the location.
  5. Click Ok to save changes or click Cancel to revert to the last saved settings and return to the Welcome screen.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\