Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200V Series) Owner's Manual

PDF

Installing the battery cable

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the battery cable and provide a visual representation of the installation procedure.
Figure 1. Installing the battery cable
Image: Installing the battery cable

Steps

  1. Connect the battery cable to the connector on the battery.
  2. Route the battery cable through the routing guides on the battery.
    NOTE: When installing the battery cable, ensure that the cable is properly routed under the routing guides.

Next steps

  1. Install the battery.
  2. Install the base cover.
  3. Install the SIM-card tray, if applicable.
  4. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\