CAUTION:The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the display assembly and provide a
visual representation of the installation procedure. Figure 1. Installing the display
assemblyFigure 2. Installing the display
assembly
Steps
Place the palm-rest assembly on a clean, flat surface.
Align and place the display assembly over the palm-rest assembly at an angle of
90 degrees.
Replace the four screws (M2.5x4) to secure the display hinges to the palm-rest
assembly.
Connect the camera cable, if available, and the display cable to the connector
on the system board.
Align and place the display-cable bracket over the cables on the system
board.
Replace the two screws (M2x3) to secure the display-cable bracket to the system
board.
Route the antenna cables through the routing guides, near the display hinges,
on the palm-rest assembly.
Connect the fingerprint-reader cable to the connector on the I/O board.
NOTE:This step applies only to computers shipped with
fingerprint reader installed.
Connect the Darwin cable to the connector on the I/O board.
Align and place the fingerprint-reader bracket on the I/O board.
Replace the screw (M2x3) to secure the fingerprint-reader bracket to the I/O
board.
Route the WWAN-antenna cables through the routing guides on the I/O board.
