Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200V Series) Owner's Manual

PDF

Installing the display bezel

CAUTION:The information in this installation section is intended for authorized service technicians only.
NOTE:This procedure applies only to Dell Pro 14 Plus laptops.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the display bezel and provide a visual representation of the installation procedure.
Figure 1. Installing the display bezel
Image: Installing the display bezel
Figure 2. Installing the display bezel
Image: Installing the display bezel

Steps

  1. Place the display assembly on a clean and flat surface.
  2. Align and place the display bezel on the display assembly.
  3. Starting from the bottom corner, press the display bezel and work around the entire bezel until it snaps onto the display assembly.

Next steps

  1. Install the display assembly.
  2. Install the WWAN card, if applicable.
  3. Install the base cover.
  4. Install the SIM-card tray, if applicable.
  5. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\