Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200V Series) Owner's Manual

PDF

Installing the fan

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the fan and provides a visual representation of the installation procedure.
Figure 1. Intsalling the fan
Image: Intsalling the fan

Steps

  1. Place the fan on the palm-rest assembly.
  2. Align the screw holes on the fan to the screw holes on the palm-rest assembly.
  3. Replace the two screws (M2x3) that secure the fan to the palm-rest assembly.
  4. Connect the fan cable to the fan-cable connector on the I/O board.

Next steps

  1. Install the base cover.
  2. Install the SIM card tray, if applicable.
  3. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\