Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200V Series) Owner's Manual

Installing the keyboard

CAUTION:The information in this installation section is intended for authorized service technicians only.

If you are replacing a component, remove the existing component before performing the installation procedure.

The following images indicate the location of the keyboard and provide a visual representation of the installation procedure.

Align and place the keyboard on the keyboard bracket.
Replace the two screws (M2x2) to secure the keyboard to the keyboard bracket.
Turn the keyboard over.
Align and place the keyboard on the palm-rest assembly.
Replace the 18 screws (M1.6x1.7) to secure the keyboard bracket to the palm-rest assembly.
Connect the keyboard cable and keyboard backlight cable (for models that are shipped with the keyboard backlight) to the connector on the touchpad.
Route the WLAN-antenna cables through the routing guides on the keyboard bracket.

Install the power button with optional fingerprint reader.
Install the I/O board.
Install the system board.
NOTE:The system board can be removed and installed with the heat sink attached in order to simplify the procedure and preserve the thermal bond between the system board and heat sink.
Install the M.2 2230 solid state drive or the M.2 2280 solid state drive, as applicable.
Install the WWAN card, if applicable.
Install the battery.
Install the base cover.
Install the SIM-card tray, if applicable.
Follow the procedure in After working inside your computer.