Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200V Series) Owner's Manual

PDF

Installing the M.2 2230 solid state drive (SSD)

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the M.2 2230 solid state drive (SSD) and provide a visual representation of the installation procedure.
Figure 1. Installing the M.2 2230 SSD
Image: Installing the M.2 2230 SSD

Steps

  1. Align and place the SSD screw holder on the system board.
    NOTE:For models shipped with M.2 2230 SSD, if the system board is replaced, ensure to transfer the M.2 2230 SSD screw holder to the replacement system board.
  2. Align the notch on the M.2 2230 SSD with the tab on the M.2 2230 SSD slot.
  3. Replace the screw (M2x4) that secures the M.2 2230 SSD to the system board.
  4. Place the SSD-shielding cover over the M.2 2230 SSD and replace the two screws (M2x3) to secure it to the system board.

Next steps

  1. Install the base cover.
  2. Install the SIM-card tray, if applicable.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\