Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200V Series) Owner's Manual

PDF

Installing the MIPI camera

CAUTION:The information in this installation section is intended for authorized service technicians only.
NOTE:This procedure applies only to Dell Pro 14 Plus laptops.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

NOTE: This procedure applies only to models shipped with MIPI camera.
The following images indicate the location of the MIPI camera and provide a visual representation of the installation procedure.
Figure 1. Installing the MIPI camera
Image: Installing the MIPI camera

Steps

  1. Align and place the MIPI camera module, along with the middle-board cable, middle board, and display cable, in the slot on the display back cover.
  2. Replace the clip to secure the MIPI camera and the camera cable to the display back cover.
    NOTE:When installing the clip to secure the MIPI camera connector to the middle-board cable, ensure that the top side (with TOP etched on it) is facing up.

Next steps

  1. Install the display hinge caps.
  2. Install the display panel.
  3. Install the display bezel.
  4. Install the display assembly.
  5. Install the WWAN card, if applicable.
  6. Install the base cover.
  7. Install the SIM-card tray, if applicable.
  8. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\