CAUTION:The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the smart card reader and provide a
visual representation of the installation procedure. Figure 1. Installing the smart card
reader
Steps
Align and place the smart card reader on its slot on the palm-rest assembly.
Replace the four screws (M2x2) to secure the smart card reader to the palm-rest
assembly.
Connect the smart card reader cable to the connector on the USH board and close
the latch to secure the cable.
Using the alignment posts and rubber grommets, place the speaker into the slot
on the palm-rest assembly.
NOTE:Ensure that the rubber grommets on the speaker are
threaded through the alignment posts. Ensure that the rubber grommets are
seated into the slot and installed on the speaker properly.
Route the speaker cable through the routing guides on the palm-rest assembly.
Replace the three screws (M1.6x1.5) to secure the speaker to the palm-rest
assembly.
