Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200V Series) Owner's Manual

Installing the USB Type-C connector module

CAUTION:The information in this installation section is intended for authorized service technicians only.

If you are replacing a component, remove the existing component before performing the installation procedure.

The following image indicates the location of the USB Type-C connector module and provides a visual representation of the installation procedure.

Align and place the USB Type-C connector module over the USB Type-C ports on the system board.
Replace the three screws (M2x5) to secure the USB Type-C connector module to the system board.

Install the system board.
NOTE:The system board can be removed and installed with the heat sink attached in order to simplify the procedure and preserve the thermal bond between the system board and heat sink.
Install the M.2 2230 solid state drive or the M.2 2280 solid state drive, as applicable.
Install the WWAN card, if applicable.
Install the battery.
Install the base cover.
Install the SIM-card tray, if applicable.
Follow the procedure in After working inside your computer.