Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200V Series) Owner's Manual

PDF

Removing the display hinge caps

CAUTION:The information in this removal section is intended for authorized service technicians only.
NOTE:This procedure applies only to Dell Pro 14 Plus laptops.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the SIM-card tray, if applicable.
  3. Remove the base cover.
  4. Remove the WWAN card, if applicable.
  5. Remove the display assembly.
  6. Remove the display bezel.
  7. Remove the display panel.

About this task

NOTE:The display hinges are a part of the display hinge caps.
The following images indicate the location of the display hinge caps and provide a visual representation of the removal procedure.
Figure 1. Removing the display hinge caps
Image: Removing the display hinge cap

Steps

  1. Using a plastic scribe, pry the hinge rubber stopper out of the left and right hinge caps.
    NOTE: Do not directly pull the display cable, Darwin cable, or the WWAN-antenna cables out of the hinge caps.
  2. Remove the two screws (M2x3) and four screws (M2.5x3.5) that secure the display hinge caps to the display back cover.
  3. Pinch and lift the left and right display hinge cap off the display back cover.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\