Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200V Series) Owner's Manual

PDF

Removing the display panel

CAUTION:The information in this removal section is intended for authorized service technicians only.
NOTE:This procedure applies only to Dell Pro 14 Plus laptops.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the SIM-card tray, if applicable.
  3. Remove the base cover.
  4. Remove the WWAN card, if applicable.
  5. Remove the display assembly.
  6. Remove the display bezel.

About this task

The following images indicate the location of the display panel and provide a visual representation of the removal procedure.
Figure 1. Removing the display panel
Image: Removing the display panel
Figure 2. Removing the display panel
Image: Removing the display panel

Steps

  1. Remove the four screws (M1.6x1.4) that secure the display panel to the display back cover.
  2. Gently flip the display panel and peel the tape that secures the display cable to the display panel.
  3. Open the latch and disconnect the cable from the connector on the display panel.
  4. Lift the display panel off the display back cover.
    CAUTION:The display panel is assembled with the display-panel brackets as a single service part. Do not pull the two pieces of elastic tape and separate the brackets from the panel.
    Figure 3. Display panel with brackets
    Image: Display panel with brackets

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\