Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200V Series) Owner's Manual

PDF

Removing the M.2 2230 solid state drive (SSD)

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the SIM-card tray, if applicable.
  3. Remove the base cover.

About this task

The following images indicate the location of the M.2 2230 solid state drive (SSD) and provide a visual representation of the removal procedure.
Figure 1. Removing the M.2 2230 SSD
Image: Removing the M.2 2230 SSD

Steps

  1. Remove the two screws (M2x3) that secure the SSD-shielding cover to the palm-rest assembly.
  2. Remove the SSD-shielding cover off the SSD.
    NOTE: If the thermal pads get separated from the shielding cover or gets adhered to the SSD while replacing the SSD, the technicians must adhere it back to the SSD cover before reinstalling the SSD.
  3. Remove the screw (M2x4) that secures the M.2230 SSD to the system board.
  4. Slide and remove the M.2 2230 SSD from the SSD slot.
  5. Lift the SSD screw holder from the system board.
    NOTE:For models shipped with M.2 2230 SSD, if the system board is replaced, ensure to transfer the M.2 2230 SSD screw holder to the replacement system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\