Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200V Series) Owner's Manual

PDF

Removing the MIPI camera

CAUTION:The information in this removal section is intended for authorized service technicians only.
NOTE:This procedure applies only to Dell Pro 14 Plus laptops.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the SIM-card tray, if applicable.
  3. Remove the base cover.
  4. Remove the WWAN card, if applicable.
  5. Remove the display assembly.
  6. Remove the display bezel.
  7. Remove the display panel.
  8. Remove the display hinge caps.

About this task

NOTE: This procedure applies only to models shipped with MIPI camera.

The following images indicate the location of the MIPI camera and provide a visual representation of the removal procedure.

Figure 1. Removing the MIPI camera
Image: Removing the MIPI camera

Steps

  1. Remove the clip that secures the MIPI camera and the camera cable to the connector on the display back cover.
  2. Using a plastic scribe, pry the camera module off the display back cover.
  3. Carefully lift the MIPI camera module, along with the middle-board cable, middle board and display cable, off the display back cover.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\