Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200V Series) Owner's Manual

PDF

Removing the USB Type-C connector module

CAUTION:The information in this removal section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the SIM-card tray, if applicable.
  3. Remove the base cover.
  4. Remove the battery.
  5. Remove the WWAN card, if applicable.
  6. Remove the M.2 2230 solid state drive or the M.2 2280 solid state drive, as applicable.
  7. Remove the system board.
    NOTE:The system board can be removed and installed with the heat sink attached in order to simplify the procedure and preserve the thermal bond between the system board and heat sink.

About this task

The following image indicates the location of the USB Type-C connector module and provides a visual representation of the removal procedure.
Figure 1. Removing the USB Type-C Connector Module
Image: Removing the USB Type-C Connector Module

Steps

  1. Remove the three screws (M2x5) that secure the USB Type-C connector module to the system board.
  2. Remove the USB Type-C connector module from the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\