Dell Pro 14 Plus/Dell Pro 14 Plus 2-in-1 PB14250/PB14250 2-in-1 (Intel Core Ultra 200V Series) Owner's Manual

PDF

Removing the RGB/IR camera

CAUTION:The information in this removal section is intended for authorized service technicians only.
NOTE:This procedure applies only to Dell Pro 14 Plus laptops.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the SIM-card tray, if applicable.
  3. Remove the base cover.
  4. Remove the WWAN card, if applicable.
  5. Remove the display assembly.
  6. Remove the display bezel.
  7. Remove the display panel .

About this task

NOTE: This procedure applies only to models that are shipped with RGB or IR camera.

The following images indicate the location of the RGB/IR camera and provide a visual representation of the removal procedure.

Figure 1. Removing the RGB/IR camera
Image: Removing the camera and display cable

Steps

  1. Disconnect the display cable from the connector on the camera module.
  2. Using a plastic scribe, pry the camera starting from the prying point at the bottom edge of the camera module.
    NOTE:While removing the RGB/IR camera module, pry the module starting from the recess at its bottom edge indicated by an arrow. Then slide along the bottom edge to release it from the display back cover.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\