Dell Latitude 3500 Service Manual

Installing the camera

Steps

  1. Connect the camera cable to the camera module [1].
  2. Route the camera cable through the routing channels [2].
  3. Using the alignment post, adhere the camera module on the display back-cover [3].
    Installing the camera

Following is the procedure to install the camera in systems with the Touch functionality.

  1. Align and replace the camera module on the display back-cover [1].
  2. Adhere the tape that secures the camera off the display back-cover [2].
    Installing the camera

Next steps

  1. Replace the display panel.
  2. Replace the display bezel.
  3. Replace the display assembly.
  4. Replace the WLAN.
  5. Replace the battery.
  6. Replace the base cover.
  7. Replace the SD memory card.
  8. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\