Dell Latitude 3500 Service Manual

Installing the IO board

Steps

  1. Using the alignment posts, place the I/O board on the palm rest and keyboard assembly [1].
  2. Replace the two (M2x3) screws that secure the I/O board to the palm rest and keyboard assembly [2].
    Image: Replacing the screws
  3. Adhere the I/O board cable to the palm rest and keyboard assembly [1].
  4. Connect the I/O board cable to the system board and close the latch to secure the cable [2].
    Installing the IO board

Next steps

  1. Replace the hard drive assembly.

    NOTE: Required for systems with 42 Whr battery

  2. Replace the battery.
  3. Replace the base cover.
  4. Replace the SD memory card.
  5. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\