Dell Latitude 3500 Service Manual

Installing the system fan

Steps

  1. Align the screw holes on the fan with the screw holes on to the palm rest and keyboard board assembly [1].
  2. Replace the two (M2x3) screws that secure the fan to the palm rest and keyboard board assembly [2].
    Installing the system fan
  3. Route the VGA board cable and the display cable through the routing guides on the fan [1].
  4. Connect the fan cable to the system board [2].
    Installing the system fan
  5. Connect the VGA board cable [1], and the display cable [2, 3] to the system board.
    Installing the system fan

Next steps

  1. Replace the battery.
  2. Replace the base cover.
  3. Replace the SD memory card.
  4. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\