Dell Latitude 3500 Service Manual

Installing the VGA daughterboard

Steps

  1. Place the VGA daughterboard and align the screw holes on the VGA daughterboard with the screw holes on the palmrest and keyboard assembly [1].
  2. Replace the two (M2x3) screws that secure the VGA daughterboard on the palmrest and keyboard assembly [2].
    Installing the VGA—daughterboard
  3. Route the VGA board cable and the display cable through the routing guides on the fan.
    Installing the VGA—daughterboard
  4. Connect the VGA board cable [1], and the display cable [2] to the system board.
    Installing the VGA—daughterboard

Next steps

  1. Replace the battery
  2. Replace the base cover
  3. Replace the SD memory card
  4. Follow the procedure in after working inside your computer

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\