Dell Latitude 3500 Service Manual

Removing the power button board with optional fingerprint reader

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the SD memory card.
  3. Remove the base cover.
  4. Remove the battery.
  5. Remove the system fan.
  6. Remove the display assembly.

Steps

  1. Open the latch, and disconnect the power button board cable and fingerprint cable from the system [1].
  2. Peel the conductive tape off the power button board [2].
    Removing the power button board
  3. Remove the two (M2x3) screws that secure the power button board to the palmrest and keyboard assembly [1].
  4. Lift the power button board, along with the cable off the palmrest and keyboard assembly [2].
    Removing the power button board

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\