Dell Latitude 3500 Service Manual

Installing the display panel

Steps

  1. Place the display panel on a flat and clean surface.
    Installing the display panel
  2. Connect the display cable to the connector at the back of the display panel and close the latch to secure the cable [1].
  3. Adhere the tape that secures the display cable to the back of the display panel [2].
  4. Turn the display panel over and place it on the display back-cover [3].
    Installing the display panel
  5. Align the screw holes on the display panel with the screw holes on the display back-cover [1].
  6. Replace the four (M2x2.5) screws that secure the display panel to the display back-cover [2].
    Installing the display panel

Next steps

  1. Replace the display bezel
  2. Replace the display assembly
  3. Replace the WLAN
  4. Replace the battery
  5. Replace the base cover
  6. Replace the SD memory card
  7. Follow the procedure in after working inside your computer

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\