Dell Latitude 3500 Service Manual

Installing the display assembly

About this task

NOTE: Ensure that the hinges are opened to the maximum before replacing the display assembly on the palmrest and keyboard assembly.

Steps

  1. Align and place the palmrest and keyboard assembly under the hinges on the display assembly.
    Installing the display assembly
  2. Seat the palmrest and keyboard assembly on the display assembly [1].
  3. Press the hinges down on the system board, and palmrest and keyboard assembly [2].
    Installing the display assembly
  4. Route the display cable through the routing guides on the palmrest and keyboard assembly [1].
  5. Replace the four (M2.5x5) screws that secure the left and right hinges to the system board, and palmrest and keyboard assembly [2].
    Installing the display assembly
  6. Connect the wireless antenna cables and affix the tape that secures it to the system board [1].
  7. Connect the display cable to the connector on the system board [2, 3].
    Installing the display assembly

Next steps

  1. Replace the WLAN.
  2. Replace the battery.
  3. Replace the base cover.
  4. Replace the SD memory card.
  5. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\