Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

OptiPlex 3070 Small Form Factor Service Manual

Installing the hard drive and optical drive module

  1. Insert the tabs on the hard drive and optical drive module into the slot on the system at 30 degree angle [1].
  2. Connect the optical drive data cable and power cable to the connectors on the optical drive [2, 3].
    Connect the cables
  3. Lower the hard drive and optical drive module so that it is placed in its slot [1].
  4. Slide the release tab to lock the module [2].
    Lock the module
  5. Route the hard drive data and power cables through the HDD-ODD release tab [1].
  6. Route the optical drive data cable and power cable through the retention clips [2].
    Route the cables
  7. Install the:
    1. HDD assembly
    2. Front bezel
    3. Side cover
  8. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\