Dell Lifecycle Controller GUI v2.70.70.70 User's Guide

PDF

Configuring system time and date

To set the time and date for the managed system:
  1. Start Lifecycle Controller. For more information, see Starting Lifecycle Controller.
  2. From the Lifecycle Controller Home page, select Hardware Configuration.
  3. In the right pane, select Configuration Wizards.
  4. Under System Configuration Wizards, click System Time and Date Configuration.
    The default system time and system date displayed in Lifecycle Controller is the date and time reported by the system BIOS.
  5. Modify the System Time and System Date (HH:MM:SS AM or PM), as required.
  6. Click Finish to apply the changes.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\