Dell Lifecycle Controller GUI v2.70.70.70 User's Guide

PDF

Enabling Lifecycle Controller

To enable access to Lifecycle Controller during system startup:
  1. Press <F2> during POST.
    The System Setup Main Menu page is displayed.
  2. Select iDRAC Settings.
    The iDRAC Settings page is displayed.
  3. Select Lifecycle Controller.
  4. Under Lifecycle Controller, select Enabled.
  5. On the System Setup Main Menu page, select Finish to save the settings.
  6. Select Yes to restart the system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\