Dell Lifecycle Controller GUI v2.70.70.70 User's Guide

PDF

Encrypting unsecure virtual disks

Make sure that the following prerequisites are met:
  • Selected controller is security-capable.
  • Security-capable virtual drives must be attached to the controller.
  • Controller must be in the local-key-encryption mode.

To encrypt the unsecure virtual drives:

NOTE: All virtual drives created on the same physical disk-drives are automatically encrypted when any one of the virtual drives is encrypted.
  1. Start Lifecycle Controller. For more information, see Starting Lifecycle Controller.
  2. In the left pane, click Hardware Configuration.
  3. In the right pane, click Configuration Wizards.
  4. On the Storage Configuration wizards page, click Key Encryption.
  5. Select the controller that is encrypted and click Next.
    NOTE: The encryption mode (Local Key Encryption) applied to the selected controller does not change.
  6. Select Encrypt unsecure virtual disks and click Next.
  7. To enable encryption, select unsecure virtual drives and click Finish.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\