Dell Lifecycle Controller GUI v2.70.70.70 User's Guide

PDF

Entering the UEFI boot manager

NOTE: Operating systems must be 64-bit UEFI-compatible (for example, Microsoft Windows Server 2008 x64 version) to be installed from the UEFI boot mode. DOS and 32-bit operating systems can only be installed from the BIOS boot mode.
The Boot Manager enables you to:
  • Add, delete, and arrange boot options.
  • Access System Setup and BIOS-level boot options without restarting.
To enter the Boot Manager:
  1. Turn on or restart your system.
  2. Press <F11> after you see the following message: 
    <F11> = UEFI Boot Manager

    If your operating system begins to load before you press <F11>, allow the system to finish booting, and then restart your system and try again.

    NOTE: On 13th generation PowerEdge servers, F11 allows you to access the Boot menu depending on the boot mode setting. If boot mode is set to UEFI, you can access only the UEFI boot mode and you cannot access the BIOS boot mode anymore.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\