Dell Lifecycle Controller GUI v2.70.70.70 User's Guide

PDF

Local key encryption mode

You can perform the following tasks while the controller is in the Local Key Encryption mode:

NOTE: For more information on the specification and configuration-related information for the PERC H710, H710P, H810, and PERC 9 controllers, see the PERC H710, H710P, and H810 Technical Guidebooks.
  • Encrypt unsecure virtual disks — Enable data encryption on all the security-capable, unsecure virtual drives.
    NOTE: This option is available if there are secure-capable virtual disks connected to a security-capable controller.
  • Rekey controller and encrypted disks with a new key — Replace the existing local key with a new key.
  • Remove encryption and delete data — Delete the encryption key on the controller and all the secure virtual drives along with its data. After deletion, controller state changes to No encryption mode.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\