iDRAC8 with Lifecycle Controller Version 2.70.70.70 Redfish API Guide

PDF

Redfish configuration

You can configure the Redfish interface on iDRAC by enabling or disabling the iDRAC attribute. If this attribute is disabled, HTTPS requests to Redfish URIs fail with an HTTP status code of 404 and an error message indicating that this attribute is disabled.

NOTE You do not need to restart the web server when enabling or disabling Redfish attribute.

Configuring Redfish service using iDRAC web interface

To enable or disable the Redfish service on iDRAC, perform the following tasks:
  1. In the iDRAC web interface, navigate to the following screen:
    • 13th generation of PowerEdge servers: Overview > iDRAC Settings > Network > Services
    • 14th generation of PowerEdge servers: iDRAC Settings > Services > Redfish

  2. Under Redfish, select Enabled and click Apply to enable the service.

Configuring Redfish service by using iDRAC RACADM

You can enable or disable the Redfish service using the iDRAC attribute iDRAC.Redfish.Enable (Read or Write).

Configuring Redfish service by using WS-MAN

The Redfish attribute iDRAC.Redfish.Enable is modeled under the existing DCIM_iDRACCardEnumeration class. You can configure the Redfish service using existing methods such as SetAttribute, SetAttributes, and ApplyAttributes of DCIM_iDRACCardService class.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\